Talk to an engineer

Dynex

DIM1600ECM17-A

1700 V, 1600 A power module in the IHM package. Supported by 2 qualified Poweronics drivers.

Driver options

What drives the DIM1600ECM17-A

The DIM1600ECM17-A is a 1700 V, 1600 A module from Dynex in a IHM package. Two Poweronics drivers are qualified against it — AP17G and AP03L, covering both on-module and off-module mounting, so the choice is mechanical rather than electrical.

AP17G drives it with no additional interface hardware. AP03L needs a module interface card fitted to the module. Gate resistors, gate–emitter capacitance, active clamping and timings are set in situ with the Power Insight Configurator, so one part number covers a range of stack designs.

Qualified against this module means we have the data to back it. If you are driving the DIM1600ECM17-A in an unusual topology or at the edge of its ratings, tell us the application and we will confirm the fit.

AP Series · On-module

AP17G

Single on-module gate drive for 1700 V high-power modules, configured in situ over the fibre-optic link.

Driver details →

AP Series · Off-module

AP03L

Dual-channel off-module driver supporting up to 3300 V, with module interface cards for XHP3, nHPD², LinPak and LV100.

Also needs a module interface card.

Driver details →

Also fits the IHM footprint

These drivers cover the IHM package, so they fit the DIM1600ECM17-A mechanically and electrically. We have not written up this exact part against them, so ask us before you design one in.

AD00XA8

All drivers listed for this module: AP17GAP03L

Get in touch

Designing with the DIM1600ECM17-A?

Tell us the topology and the application and we will confirm the driver, the module interface card and any DC-DC converter you need.